High Temperature Organic Silicone Heat Resistant Rust Proof Prevention Paint Anti - Corrosive Corrosion Coatings for Stainless Steel

Detailed Product Description Product Description • Two pack, dry at room or higher temperature • On surface likely to reach up to 300-600°C • VOC less than 550 g/L Intended Uses • For use at all kinds of high temperature equipment, such as ship stacks. • For use at Newbuilding, Maintenance and...

Product details

Detailed Product Description

Theoretical Coverage:15.2㎡/L At Typical Film ThicknessColor:According To Customers' Requirement
Finish/Sheen:Semi-GlossType:Topcoat
Recommended Dry Film Thickness:3.25 Microns Dry ( 66 Microns Wet)Application Method:Spray


Product Description
• Two pack, dry at room or higher temperature
• On surface likely to reach up to 300-600°C
• VOC less than 550 g/L

Intended Uses
• For use at all kinds of high temperature equipment, such as ship stacks.
• For use at Newbuilding, Maintenance and Repair or Maintenance
• For use at petroleum smoke pipeline or oven.

Product Information
• Volume Solids 38%±3%
• Finish/Sheen Semi-Gloss
• Typical Film Thickness 25 microns dry ( 66 microns wet)
• Theoretical Coverage: 15.2㎡/L at typical film thickness
• Mix Ratio: one pack
• Method of Application
   Airless Spray Tip size range 0.38-0.53mm
   Output Pressure ≥17MPa
   Air Spray Tip size range 2-3mm
   Output Pressure ≥0.4MPa
   Brush/Roller For small area only
• Thinner: Not recommended. Use water only in exceptional circumstances(max 5% by volume)
• Drying Information
   10°C 25°C 35°C
   Touch Dry 4H 3H 1H
   Hard Dry 36H 24H 16H
   Pot Life Not applicable
   Overcoatings Data: Substrate Temperature
   Overcoated By
   10°C 25°C 35°C
   725-W61-01 36H no 24H no 16h no
• Storage: Store in cool and dry conditions, Well ventilate. Keep away from hot and fire.Store temperature should be higher than 0°C.
   Shelf Life: 12Months minimum at 25°C.Subject to re-inspection thereafter.
• Pack Size: 19.8kg/18L in 20L container
• Flash Point Greater than 28°C

Limitations
• Apply in good weather, Temperature of the surface to be coated must be least 3°C above the dew point when the humidity is lower than 85%
• The dry time and over coating interval may change according to the environment factors.
• Forbid to trample or pullute the surface of AF3-1 and coat the next paint before the film is hard dry.

36-1.jpg


Related Products
Feedback

Our Service

The company has been developed a series of ship coating products have been passed approval by CCS, LR, and DNV. The coatings systems hold independent intellectual property rights meet the requirements of corrosion on steel and concrete structures in harbors, wharfs, bridges, power stations, petrol-chemicals and civil engineering.

Feedback

Contact Us

Address:Room 214 2F No.149-2 Huangpu AVE Middle, TianHe District, Guangzhou City, China

Tel: 86-20-38993165

Fax: 86-20-38993165

E-mail: sales@huisinschem.com

CopyRight© Huisins New Material Technology Co.,Limited

Huisins New Material Technology Co.,Limited